Table of Contents
Advertisement
Complete the following steps to install the BladeCenter PCI Express I/O Expansion
Unit:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. Remove the blade server cover and set it aside. See "Opening and removing
3. Remove the connector cover or any optional card from the high-speed
4. Lower the expansion unit so that the slots at the rear slide down onto the cover
5. Carefully close the expansion unit as shown in Figure 22 on page 29 until it
30
QS21 Installation and User's Guide
on page 19.
the blade server cover" on page 22 for further information.
connector. Figure 12 on page 24 shows the location of the high-speed
connector.
pins at the rear of the blade server, as shown in Figure 22 on page 29.
clicks into place.
Advertisement
Table of Contents
