Completing The Installation - IBM LS42 - BladeCenter - 7902 Installation And User Manual

10. If you removed any of the following expansion cards while you installed the
11. For device-driver and configuration information to complete the installation of
12. If you have other devices to install or remove, do so now; otherwise, go to

Completing the installation

To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see "Installing the
2. If you removed an expansion unit from a double-width type of blade server,
3. Close the blade server cover (see "Closing the blade server cover" on page 49).
4. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
5. Turn on the blade server (see "Turning on the blade server" on page 13).
6. For certain optional devices, you might have to run the blade server
46
BladeCenter LS22 and LS42 Type 7901 and 7902: Installation and User's Guide
concurrent KVM card, reinstall the card:
v Small-form-factor card (see "Installing a small-form-factor expansion card"
on page 41).
v Combination-form-factor card (see "Removing a combination-form-factor
expansion card" on page 36)
v High-speed expansion card (see "Removing a high-speed expansion card"
on page 36)
the cKVM card, see the documentation that comes with the cKVM card.
"Completing the installation."
bezel assembly" on page 47).
reinstall the expansion unit (see "Installing an expansion unit" on page 48).
If an expansion unit or MPE is installed, close the cover on the expansion unit.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
server in a BladeCenter unit" on page 50).
Configuration/Setup Utility program to configure the blade server (see
Chapter 4, "Configuring the blade server," on page 53).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade server
flashes slowly before you press the power-control button.