Closing The Blade Server Cover - IBM LS42 - BladeCenter - 7902 Installation And User Manual

Closing the blade server cover

Attention:
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
The following illustration shows how to close the blade server cover.
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade cover before installing the blade server.
Attention:
cover is installed and closed. Do not attempt to override this protection.
To close the blade server cover, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. If you removed the bezel assembly, install it (see "Installing the bezel assembly"
3. If you removed an expansion unit from a double-width type blade server, install
4. Lower the cover so that the slots at the rear slide down onto the pins at the rear
5. Pivot the cover to the closed position, as shown in the illustration, until it clicks
You cannot insert the blade server into the BladeCenter unit until the
You cannot insert the blade server into the BladeCenter unit until the
"Installation guidelines" on page 17.
on page 47 for instructions).
it (see "Installing an expansion unit" on page 48 for instructions).
of the blade server, as shown in the illustration. Before you close the cover,
make sure that all components are installed and seated correctly and that you
have not left loose tools or parts inside the blade server.
into place.
Chapter 3. Installing optional devices
49