IBM BladeCenter JS21 Types 8844 Service Manual page 49

v If the system hangs on a progress code, follow the suggested actions in the order in which they are listed
in the Action column until the problem is resolved.
v See Chapter 3, "Parts listing, Types 7988 and 8844," on page 137 to determine which components are
CRUs and which components are FRUs.
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Progress code
CA26FFFF
CA26ttss
CA279001
CA2799FD
CA2799FF
Description
An extended waiting time was required
for lpevent to finish
Waiting for lpevent of type tt and subtype
ss.
The firmware image contains a firmware
module that is not already on the server.
A firmware update module is being read. Shut down the blade server; then, restart it
A firmware update module is being
written.
Action
1. Reboot the blade server.
2. Check for server firmware updates; apply if
available.
3. Go to "Checkout procedure" on page 106.
4. Replace the system board and chassis
assembly.
1. Restart the blade server.
2. Go to "Checkout procedure" on page 106.
3. Replace the system-board and chassis
assembly.
1. Look for a BA27xxxx error in the error logs
to see if a firmware installation error
occurred. Resolve any problems that are
found and retry the firmware installation.
2. Retry the firmware installation with another
firmware image.
3. Go to "Checkout procedure" on page 106.
4. Replace the system board and chassis
assembly.
using the permanent boot image and reject the
temporary image.
Shut down the blade server; then, restart it
using the permanent boot image and reject the
temporary image.
Chapter 2. Diagnostics
33