IBM BladeCenter JS21 Types 8844 Service Manual page 113

SRN Description
A1D-04x A non-critical error has been detected, an
internal service processor memory error.
A1D-05x A non-critical error has been detected, a
service processor error accessing special
registers.
A1D-06x A non-critical error has been detected, a
service processor reports unknown
communication error.
A1D-07x A non-critical error has been detected,:
Internal service processor firmware error or
incorrect version.
A1D-08x A non-critical error has been detected,
another internal service processor hardware
error.
A1D-09x A non-critical error has been detected, a
service processor error accessing vital
product data EEPROM.
A1D-12x A non-critical error has been detected, a
service processor error accessing fan sensor.
A1D-13x A non-critical error has been detected, a
service processor error accessing a thermal
sensor.
FRU/action
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
1. Check the BladeCenter management module event
log; if an error was recorded by the system or if a
checkpoint code is displayed on the console, see
"POST checkpoint codes" on page 9.
2. If no entry is found, replace the system-board and
chassis assembly.
97
Chapter 2. Diagnostics