Error Cords Of Auto-Equalizing Function - Pioneer FH-P8800 Operation Manual

10. When Auto-equalizing is completed, a message is displayed as below.
When correct measurement of car interior acoustic characteristics is not possible, an error
message is displayed. (Refer to error messages on this page.)
11. To cancel the Auto-equalizing mode, press any button.
12. Store the microphone carefully in the glove compartment.
Store the microphone carefully in the glove compartment or other safe place. If the micro-
phone is subjected to direct sunlight for an extended period, high temperatures may cause
it to deform, change color and malfunction.
7 When Auto-equalizing was performed correctly:
AUTO EQ ON applies to, and the "AUTO EQ" indicator lights for, all equalizer curves
that are called (refer to page 39.). The called equalizer curve is set after it is corrected by
Auto-equalizing.

Error Cords of Auto-equalizing Function

When correct measurement of car interior acoustic characteristics is not possible with the
Auto-equalizer, the following error messages are displayed. After checking, try again.
Display
ERROR-1
ERROR-2
ERROR-3
Cause
Microphone is not connected.
The microphone cannot pick up
the measuring tone of the front
and rear speakers.
The surrounding noise level is too
high.
"AUTO EQ"
Remedy
Plug in the supplied microphone
securely into the jack.
Confirm that the speakers are
connected correctly.
Set the input level setting of the power
amp connected to the speakers
correctly.
Correctly set the microphone.
Stop your car in a place that's as quite
as possible, and switch off the engine
and air conditioner or heater.
Correctly set the microphone.
44