Connecting Through The Com Port; Restoring Factory Settings - 3Com 3CRWE776075 Owner's Manual

Connecting
through the Com
Port
Restoring factory
settings
Instead of using an IP address to configure the Access Point a Null
modem cable, connected to the AP's serial port, can be used.
In your terminal settings ensure that the following configuration is
met:
Bits per Second – 9600
Data Bits – 8
Parity – None
Stop bits – 1
Flow Control - none
Once connected enter the user name and password. The default
values are as follows:
Username: admin
Password: password
Once logged in, type"?" for a list of commands.
The Access Point can be reset to the default factory settings either
through the web browser (see Backup/ Restore Settings) or
manually.
To restore the settings manually, insert a pointed object (such as
the end of a straightened paper clip) into the reset hole on the
back of the Access Point, and hold for five seconds.
RESET RESET

Connecting through the Com Port

Reset Hole
45