Table of Contents
Advertisement
OPERATIONS
OPERATIONS
POWER Indicator
Power Switch
Power ON
1. Check that the power cord is connected correctly.
2. Set the power switch to [ | ]. The standby mode is selected, and the POWER indicator is turned to
orange.
3. Press the STANDBY/ON button
Warm-up begins and the POWER indicator blinks in green.
4. The POWER indicator ceases blinking and turns to green when power is on. Remove the lens
cap.
5. Adjust picture size using the zoom knob.
6. Adjust focus using the focus ring .
Power OFF
1. Press the STANDBY/ON button
message "Power off?" will appear on the screen, and the message will disappear by any operation
or no operation for 5 seconds. During this message indication, press the STANDBY/ON
button again. The projector lamp is extinguished and lamp cooling begins. The POWER indicator
blinks orange during lamp cooling. Pressing the STANDBY/ON button
the POWER indicator is blinking.
2. The system assumes the Standby mode when cooling is complete, and the POWER indicator
ceases blinking and changes to orange. Check that the indicator is orange and set the power
switch to [O].
3. The POWER indicator is extinguished when power is off. Do not forget to attach the lens cap.
WARNING • Please read this manual, and the separate "SAFETY
INSTRUCTIONS" thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE
• Except in emergencies, follow the above-mentioned procedure for turning power off.
Incorrect procedure will reduce the life of the projector lamp and LCD panel.
• To prevent any trouble, turn on/off the projector when the computer or video tape recorder is OFF.
Providing a RS-232C cable is connected, turn on the computer before the projector.
• When a projector continues projecting the same image, the image may remain as an afterimage.
Please do not project the image same for a long time.
STANDBY/ON Button
on the control panel or the remote control transmitter.
on the control panel or the remote controller. Then,the
STANDBY/
ON Button
Zoom Knob
Focus Ring
Lens Cap
has no effect while
STANDBY/ON
BLANK
LASER
VIDEO
RGB
AUTO
MENU
KEYSTONE
MENU SELECT
POSITION
RESET
FREEZE
PinP
MAGNIFY
MUTE
OFF
VOLUME
ENGLISH-9
ENGLISH-9
Advertisement
Table of Contents
