Operations; Power On; Power Off - Dukane 28A8751 User Manual

Hide thumbs Also See for 28A8751:
Table of Contents

Advertisement

OPERATIONS

OPERATIONS
STANDBY/ON Button
POWER Indicator
Power Switch
Slide Lens door

Power ON

1. Check that the power cord is connected correctly.
2. Set the power switch to [ | ]. The standby mode is selected, and the POWER indicator is turned to
orange.
3. Press the STANDBY/ON button
begins and the POWER indicator blinks in green.
4. The POWER indicator ceases blinking and turns to green when power is on. Open the slide lens
door.
5. Adjust picture size using the Zoom knob.
6. Adjust focus using the Focus ring.

Power OFF

1. Press the STANDBY/ON button
message "Power off?" will appear on the screen,and the message will disappear by any operation
or no operation for 5 seconds.During this messsage indication,press the STANDBY/ON
button again. The projector lamp is extinguished and lamp cooling begins. The POWER
indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button
effect while the POWER indicator is blinking.
2. The system assumes the Standby mode when cooling is complete, and the POWER indicator
ceases blinking and changes to orange. Check that the indicator is orange and set the Power
switch to [O].
3. The POWER indicator is extinguished when power is off. Do not forget to close the lens door.
WARNING • Please read this manual, and the separate "SAFETY
INSTRUCTIONS" thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE
• Except in emergencies, do not turn off unless the POWER indicator is orange as it will
reduce the life of the projector lamp.
• To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF.
Providing a RS-232C cable is connected, turn on the computer before the projector.
• When a projector continues projecting the same image, the image may remain as an afterimage.
Please do not project the image same for a long time.
ENGLISH-8
Zoom knob
Focus ring
on the control panel or the remote controller. Warm-up
on the control panel or the remote controller. Then, the
http://www.pureglare.com.au
STANDBY/
STANDBY/ON
VIDEO
RGB
ON Button
KEYSTONE
MENU
SELECT
MENU
RESET
POSITION
MAGNIFY
FREEZE
VOLUME
has no

Advertisement

Table of Contents
loading

Table of Contents