Setting Input Ports Using Menu; Preparing For Menu Operations; Checking Main Projector's Operating Status - Dukane 9007WU User Manual

5. Setting input ports using menu

5.1 Preparing for menu operations

If Simple Stack without an RS-232C connection is used, press the button
corresponding to the port on the remote control or the INPUT button on the
projector to select the port to which the cable is connected. For setting of
MONITOR OUT, refer to SETUP menu in Operating Guide.
This completes the setting.
If Intellectual Stack with the RS-232C connection is used, all settings or
modifications related to Intellectual Stack menu operations must be performed on
the Main projector. The Main projector functions according to the input settings for
Intellectual Stack.

5.2 Checking Main projector's operating status

For Intellectual Stack, all settings or modifications related to menu operations
must be performed on the Main projector. Before operating the menu for
Intellectual Stack, check if the Main projector is functioning.
1.
Press the MENU button on the remote control.
2.
If the MENU dialog as shown on the right appears on
the screen, the two projectors are operating in DUAL
mode and the Main projector is operating.
Go to 5.3 Setting the menu. ( 25 )
3.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION
> STACK
STACK menu will appear on screen.
( Operating Guide → OPTION menu)
4.
Check the STACK MODE setting in the
STACK menu.
- If MAIN is displayed, the Main projector is operating. Go to 5.3 Setting the
menu. ( 25 )
- If SUB is displayed, the Main projector is turned off and the Sub projector is
operating.
24