Table of Contents
Advertisement
THE LAMP (continued)
Replacing the lamp
All projector lamps will wear out eventually. If used for long periods of time, the image could become
darkened, and the color contrast could be impacted as well. We recommend that you replace your lamps
early. If the LAMP indicator turns red, the lamp needs to be replaced. (See "Regarding the Indicator
Lamps" (Vol.2
9
Turn off the projector, and unplug the
1
power cord. Allow the lamp bulb to cool
for at least 45 minutes, and prepare a
new lamp (serial number: DT00571)
After making sure that the projector has
2
cooled adequately, slide the knob of a
lamp cover lock as shown in the figure.
Then, one side of the lamp cover is
raised. Pull up the lamp cover and
remove it, as shown in the figure
Knob of Lamp
Cover Lock
Unscrew the 3 screws, and slowly pull
3
out the lamp by the handle
• Be careful not to touch the inside of the lamp case.
ATTENTION
• Do not use with lamp cover removed.
• Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always when replacing
the lamp.
NOTE
•
The LAMP indicator is also red when the lamp unit reaches high temperature.
Before replacing the lamp, switch power off, wait approximately 20 minutes, and switch power on
again. If the LAMP indicator is still red, replace the lamp.
28
) for details.)
• Make sure that the screws are screwed in firmly. Loose screws could result in damage or injury.
Insert the new lamp, and
4
tighten the 3 screws firmly to
lock it in place
Interlocking the 2 tabs of the
5
lamp cover to the projector,
put the lamp cover on the
projector.
Then push the point of the
lamp cover to fix it, as shown
in the figure.
Make sure that the lamp
cover does't come up
Turn on the projector power,
6
and reset the lamp timer
• To reset the lamp timer, from the
OPTION menu, select the LAMP
TIME. (Vol.2
Tabs
Push
)
7
Advertisement
Table of Contents
