Replacing The Lamp - Dukane 401-8777 User Manual

» Replacing the Lamp
After your lamp has been operating for 2000 hours (up to 3000
the cabinet will blink red and the message [The lamp has reached the end of its usable life. Please replace the
lamp.] *1 will appear. Even though the lamp may still be working, replace it at 2000
hours to maintain optimal projector performance. After replacing the lamp, be sure to clear the lamp hour meter.
(→ page 49)
CAUTION
• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector off,
wait 30 seconds, turn off the main power switch and then disconnect the power cable. Allow at least one hour
for the lamp to cool before handling.
• DO NOT REMOVE ANY SCREWS except two lamp case screws. You could receive an electric shock.
• Do not break the glass on the lamp housing.
Keep finger prints off the glass surface on the lamp housing. Leaving finger prints on the glass surface might
cause an unwanted shadow and poor picture quality.
• The projector will turn off and go into standby mode after 2100
If this happens, be sure to replace the lamp. If you continue to use the lamp after 2000
in Eco mode) of use, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not
touch them as the pieces of glass may cause injury. If this happens, contact your dealer for lamp
replacement.
1 NOTE: This message will be displayed under the following conditions:
*
• for one minute after the projector has been powered on
• when the POWER ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote control is pressed
To turn off the message, press any button on the projector cabinet or the remote control.
To replace the lamp:
Optional lamp and tools needed for replacement:
• Replacement lamp 456-8777
1. Place the projector on a soft cloth and turn it over to access the lamp cover on the bottom.
*1 hours in Eco mode) or longer, the LAMP indicator in
*1 (up to 3100 *1 hours in Eco mode) hours of service.
52
6. Maintenance
*1 (up to 3000 *1 hours in Eco mode)
*1
hours (up to 3000
*1
hours