Table of Contents
Advertisement
Operation
Starting up the projector
1.
Plug the power cord into the projector and into
a power outlet. Check that the POWER
indicator light on the projector lights orange
after power has been applied.
•
Please use the original accessories (e.g. power cable)
only with the device to avoid possible dangers such as
electric shock and fire.
•
If Direct power on function is activated in the
SYSTEM SETUP: Basic > Operation Settings menu, the projector will turn on automatically
after the power cord has been connected and power has been applied. See
On" on page 50
2.
Press
the remote control to start the projector. The
POWER indicator light flashes and stays
green when the projector is on.
The start up procedure takes about 10-20
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Use the focus ring/focus slide
lever to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
3.
If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
4.
If you are prompted for a password, press the
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 29
for details.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
detect a valid signal, the message 'No Signal'
will continue displaying until an input signal is
found.
You can also press SOURCE on the projector or remote control to select your
desired input signal. See
for details.
I
Power on the projector or ON on
I
"Switching input signal" on page 31
"Direct Power
for details.
Operation
25
Advertisement
Table of Contents
