Select the lamp saver mode
•
Using the remote control.
Press Smart Eco and Highlight Lamp Mode and press
Economic/Smart Eco.
•
Using the OSD menu.
1.
Press MENU/EXIT and then press
until the SYSTEM SETUP: Advanced menu
is highlighted.
2.
Press
MODE/ENTER. The Lamp Settings page
displays.
3.
Highlight Lamp Mode and press
select Normal/Economic/Smart Eco. The lamp brightness vary from the
different lamp mode,see the description list in table below.
Lamp Mode
Normal
Economic
Smart Eco
•
If the Economic mode is selected, the light output will be reduced and result in darker
projected pictures.
Use build-in test pattern
You can adjust the image shape and focus status by observing
the input signal content, or using the test pattern build-in
OSD manual from OSD for better observe the shape
changed.
Open the OSD menu and go to the SYSTEM SETUP:
Advanced > Test Pattern > On. Press MODE/ENTER.
The Test Pattern displays.
42
Operation
to highlight Lamp Mode and press
Description
100% lamp
brightness.
80% lamp power consumption.
This is default setting. Lamp power consumption will save from 30% to
100% dynamically by detecting the content brightness level.
/
/
/
to
to select Normal/