Dual XDVD710 Installation & Owner's Manual page 33

DVD Operation - Parking Brake Initialization
CAUTION !!!
IT'S UNLAWFUL TO OPERATE
A VEHICLE WHILE VIDEO IS
DISPLAY IN THE DRIVERS
VIEWING AREA
ENGAGE EMERGENCY BRAKE
TO ENJOY VIDEO
Front TFT Video Initialization
Parking Brake Initialization
Situation 1
Parking Brake Initialization
Situation 2
SAFETY WARNING
• The video display of the in-dash unit will not operate while the vehicle is
moving. This is a safety feature to prevent driver distraction. In-dash video
functions will only operate when vehicle is in Park and the PARKING BRAKE
is engaged. It is illegal in most states for the driver to view video while the
vehicle is in motion. Refer to local laws in your area.
• Audio can be heard while the monitor is closed.
• The vehicle must be in park and the parking brake applied to view video on the
in-dash monitor.
• As a safety feature, "ENGAGE PARKING BRAKE" blue screen will show on
the display when the vehicle's parking brake is not engaged. Video display
on the front monitor isn't allowed until the PARKING BRAKE is engaged. By
connecting the yellow/blue PARKING BRAKE wire to brake switch circuit as
described below, DVD and AV1 audio can be heard while the vehicle is in
motion without engaging the parking brake.
Follow these two initialization procedures carefully to allow video playback on
XDVD710 front panel TFT:
There are two situations that start the PARKING BRAKE sequence.
First situation is while driving:
1) Stop vehicle, put in Park, make sure PARKING BRAKE is off/released
) Depress PARKING BRAKE for 1 second
3) Release PARKING BRAKE for 1 second
4) Depress PARKING BRAKE permanently
Note:
Once above procedure 1-4 is completed, video will display in approx. 6 seconds.
Second situation is while already parked and the PARKING BRAKE is already
applied:
1) Keep vehicle in Park, PARKING BRAKE should be on
) Release PARKING BRAKE for 1 second
3) Depress PARKING BRAKE for 1 second
4) Release PARKING BRAKE for 1 second
5) Depress PARKING BRAKE permanently
Notes:
Once nd procedure 1-5 is completed, video will display in approx. 6 seconds.
The transition time must be less than  seconds between depress and release.
This procedure will have to repeated if the IGN is turned off.
XDVD710 OPERATION
3