LG WM2442HW Owner's Manual page 7

INSTALLATION INSTRUCTIONS
[] Electrical connection
- Do not use an extension cord or double adapter
- [f the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard
- if the machine will not be used for an extended time. unplug it and shut off the water supply
- Connect the machine to a grounded outlet in accordance with current wiring regulations
• The appliance must be positioned so that the plug is easily accessible
CAUTIONJ Concerning the Power Cord
Most appffances recommend they be placed upon a dedicated circuit;that is, a single outMt circuit which powers only that
applMnce and has no additional outfets or branch circu_ Check the specificaffon page of this owner's manual to be
certaln r
Do not overload wall outlets Overloaded wail outlets, loose or damaged walt outlets, extension cords, frayed power cords,
or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire.
Periodically examine the cord of your appliance, and if its appearance indicates damage or deterioration, unplug it.
discontinue use of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or
walked upon Pay particular attention to plugs, wall outIets, and the point where the cord exits the appliance,
m=Connecting water supply hose
• Water supply pressure must be between
45 and 145 PS! (30.-1000 kPa)
• Do not crossthread when connecting inlet hose to
the valve
• If the water supply pressure is more than 145 PSI,
a pressure reducing device shouM be instaffed
. Two Sealing washers are supplied with the water
inlet hoses to prevent water leaks
• Check for leakage of washing machine connections
by tt,rning the tap compMtely on
• Periodically check the condition of the hose and
replace the hose if necessary
. Make sure that there Is no kink in the hose and that
it is not crushed
. Be sure that the two water input ports are connected
to the correct water faucets The connector for hot
water is co_ored red
NOTE: Washing Machine is to be connected to the water mains using new hoses.
Old hoses shouhl not be used.
Repairs to 1he washing machine must (rely he carried out by qualified personneL Repairs carried out by
inexperienced persons may cause iejtiry or serious malfunctioning. Contact your local service center.
Do not install your washing maddne in a reem where temperatures below freezing may occur.
Frozen lnxses may burst under pressure. The reliability of the electronic control trait may be impaired
at temperatures below the freezing point.
If the appliance is delivered in the winter monllLs and temperatures are belnw freezing,
store the washing machine at room temperature for a few hours before putting it into operation°
7