Haier GDZ10-0677 User Manual page 18

• The LED display indicates remaining time of a cycle. If setting "Wrinkle Saver" in
standby status, the LED display indicates 1 hr.
7. Press "Start/Pause" button
• When starting the machine, first close the door and then press this button.
• If pause is needed during machine operation, press this button. Pressing again will
resume operation.
Autodry Cycle Remain Time
Normal
Heavy Duty
Whites
Start/
Bulky
Pause
Press Free
Delicate
Touch Up
Custom Timed
0-180
minutes
Pass for Rack
• Wrinkle saver 1- 9 hours
• Sensor Dry Levels: VERY, NORMAL,DAMP
• Temp Levels: High, Medium, Low, No Heat
• Signal: Louder, Softer, Off
Touch Up Cycle
• You can use the "Touch Up" cycle to remove wrinkles from clean clothes
packed tightly in a suitcase or closet.
Custom Cycle
• To store your desired settings for future use, the "Custom" function can be used.
• The dryer can memorize programs defined by user and display the previous
program upon next application of this function.
Use details are as follows (Features may vary per model purchased)
After powering on, press "Auto-Dry Cycles" until "Custom" status, then set
"Timed-Dry Cycles" to Timed Dry or Rack Dry and set status of other buttons.
Press "Start/Pause" button or after half a minute, the program defined by user will be
stored and will be directly displayed upon next use.
Note: The"Sensor Dry Level" button will be inactive during use of "Custom" function
and "Touch Up" cycle.
17
60
60
58
72
58
50
25
30
Dry
60
Dry
Sensor
Temp
Dry Level
very Medium
very Medium
very High
very High
very Medium
Very Low
Very Low
N/A High
N/A Air Dry
English
Signal
High
High
High
High
High
High
High
High
High