Table of Contents
Advertisement
ULTRA FLAME DV "0" Clearance Fireplace
LOG INSTALLATION
1. Remove the glass front.
2. Locate the log grate in the retainers in the right and left rear corners.
3. Place the rear log (1) against the rear log stop. Make sure grooves under the log line up with
the grate.
4. Place logs 2 and 3 against the stops in the middle of the grate. Again see that grooves in the
bottom of the logs line up with the grate.
5. Place log 4 into the grooves over the right as shown.
6. Log 5 sits over log 4 at the back and on the grate in front.
7. Log 6 sits between log 4 and 5 as shown.
8. Put the glass front assembly back in place.
24
Advertisement
Table of Contents
