Ricoh Aficio SP C811DN Software Manual page 264

6. Monitoring and Configuring the Printer
Error: Rem. Certificate Renewal
Error: USB Board
Error: USB Interface
Error: Wireless Board
Error: Wireless Card
Exceed Booklet Stapling Limit
Full: Finisher
6
Full: Finisher Booklet Tray
Full: Finisher Shift Tray
Full: Finisher Shift Tray 1, 2
Full: Finisher Upper Tray
Full: Hole Punch Receptacle
Full: Log Data Capacity
Full: Standard Tray
Full: Waste Toner
Hex Dump Mode
Immed. Trans. not connected
Immediate Transmission Failed
Immed. Trans. not connected
Independent-supplier Toner
In Use: Finisher
262
Messages Description
An error has occurred in the remote certificate
renewal.
An error has occurred in the USB board.
An error has occurred in the USB interface.
An error has occurred in the wireless board.
Wireless card is not inserted during start up, or
the IEEE 802.11b interface unit or the wireless
card is taken out after start up.
The printing has exceeded the stapling limit of
the booklet finisher.
Finisher tray is full.
Finisher booklet tray is full.
Shift tray of Finisher is full.
The shift tray 1 and 2 of Finisher are full.
The upper tray of Finisher is full.
Punch Chip receptacle for hole punch is full.
Log data capacity is full.
Standard output tray is full.
Waste toner is full.
It is a hex dump mode.
It did not connect directly with the other party of
the transmission.
An error has occurred while transmitting directly.
It did not connect directly with the other party of
the transmission.
Toner that is not recommended is set.
Other functions is using Finisher.