Advertisement
3. Within five seconds, push one of the four
pushbuttons.
Whenever you press that button, the preset station will
return. In addition to the four stations set
as
above, up to
three additional stations may be preset on each band by
pressing two adjacent buttons at the same time.
1. Tune in the desired station.
2. Press the SET pushbutton. (SET appears in the
display.)
3. Within five seconds, push any two adjacent
pushbuttons at the same time. (The station will return
when the same adjacent buttons are pressed again.)
Setting the Tone
TREB:
Slide the TREB lever up to increase the treble
response. I f the station is weak or noisy, slide the treble
lever down to reduce the noise.
Setting the Clock
I.
Press the SET pushbutton.
2. Within five seconds, press and hold SCAN until the
3. Press and hold SEEK until the correct minute
correct hour appears on the display.
appears on the display.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Longer tapes are so
thin they may not work well in this player.
With the radio on, push a tape into the slot marked
AUTO REVERSE (tape side goes in first).
When the tape is playing, use the upper and lower knobs
for volume, balance and fade just as you did for the
radio. The lighted arrows indicate which side of the tape
is being played.
BASS: Slide the BASS lever up to increase the bass
response. Adjust the bass lever to give a pleasing sound
to your ear.
3-7
Advertisement
