4 Starting the NAUTICAST
4.1 Initial Set Up of the NAUTICAST for operation
ATTENTION: AUTHORITIES MANADATE THAT YOU ENTER THIS INFORMATION.
After installing the antennas and hardware the following User, Voyage related and Ship
Settings data needs to be entered. Upon Start-up (Applying power) enter the following
information.
a) Enter MMSI Number - See paragraph 4.2 on entering information.
During the initial boot or after "factory settings" the user is asked to enter a valid MMSI
number. As long as this is not done, the system does not transmit. This appears as
Alarm-ID 56 with the text "AIS: ENTER MMSI NUMBER".
b) Enter IMO Number, Designated Area Code (DAC) and European Ship Number (ESN)
- See paragraph 4.2 on Entering information.
c) Select AIS Mode – According to the local requirements you have to select the AIS
Mode between Inland AIS or SOLAS AIS.
See paragraph on altering this information.
d) Ship Settings Data - After initial entry of the Ship Settings Data any changes in the
information below should be edited accordingly. See Paragraph 4.3 on entering
information.
•
Enter Call Sign
•
Enter Ships Name
•
Enter Length of Ship
•
Enter Beam of Ship
•
Enter Internal GPS antenna Position
•
Enter External GPS Antenna Position (If Applicable).
•
Enter Ship Type
e) Voyage related Data – After initial entry of the Voyage related Data any changes in
the information below should be edited accordingly.
See Paragraph 4.4 on entering information.
•
Enter Cargo Type
•
Enter Draught
•
Enter Destination
•
Enter ETA
•
Enter Navigation Status.
f) Password – Service and User passwords see section 4.5
Installation Manual
LAT: N/A
SOG: N/A
LON: N/A
COG: N/A
IntN/A:
STOP
++++++++++++++++++++++++++++++++++++++++
Time 24:60 00/00
[!] ALARM ID:56
AIS: ENTER MMSI NUMBER
Please press OK to enter MMSI number!
Tx temporary suppressed
++++++++++++++++++++++++++++++++++++++++
00/00/00
24:60:60
! 7A 1T
32
Y1-03-0212 Rev.B