Replacing The Oven Light - CDA RV 1200 Series Installation Instructions Manual

Table of Contents

Inside of ovens

Every oven should always be cleaned after use when it has cooled

down.

The cavity should be cleaned using a mild detergent solution and

warm water. Suitable proprietary chemical cleaners may be used

after first consulting with the manufacturers recommendations

and testing a small sample of the oven cavity.

Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity sur-

face.

NOTE: The manufacturers of this appliance will accept no responsibility for damage

caused by chemical or abrasive cleaning.

Let the oven cool down and pay special attention no to touch the hot heating

elements inside the oven cavity.

Replacing the oven light

Before any maintenance is started involving electrical parts of the

appliance, it must be disconnected from the power supply.

– Let the oven cavity and the heating elements cool down;

– Unscrew the protective cover C (fig. 26);

– Unscrew and replace the bulb B with a new one suitable for high temperatures

(300°C) having the following specifications: 230-240V 50 Hz, 15W, E14 and same

power (check watt power as stamped in the bulb itself) of the replaced bulb.

– Refit the protective cover.

NOTE: Oven bulb replacement is not covered by your guarantee

Fig. 26

Table of Contents