Table of Contents
Advertisement
Message
Push in
the Tray
Empty
Exit Tray
Replace Black
Toner (K)
Reinsert Black
Toner (K)
Operation Error
Please Press Set
Operation Denied
While Printing
ServCallJ1
Close
Front Cover
Replace Magenta
Toner (M)
Reinsert Magenta
Toner (M)
Out of Memory
Please Press Set
Meaning and Action
None of the trays are properly inserted.
Action:
Push the all paper trays completely back into the printer.
The face down tray is full.
Action:
Remove the paper from the face down tray.
The black toner cartridge is empty.
Action:
Replace the black toner cartridge.
See 8.1.2 "Replacing the Toner Cartridges"
There is no black toner cartridge inserted in the printer or the
cartridge is improperly set.
Action:
Grip the levers at each end of the black toner cartridge with your
fingers, then push down firmly to rotate the levers forward to
install the cartridge.
See 8.1.2 "Replacing the Toner Cartridges"
The request from the computer could not be printed.
Action:
Press the <Form Feed/Set> button and cancel printing. Check
the printer driver settings and reprint.
An illegal operation was performed on the control panel during
printing.
Wait until printing finishes.
This is a warning message. Contact your dealer or Brother
authorized service representative.
The front cover is open.
Action:
Make sure that the front cover is properly closed.
The magenta toner cartridge is empty.
Action:
Replace the magenta toner cartridge.
See 8.1.2 "Replacing the Toner Cartridges"
There is no magenta toner cartridge inserted in the printer or the
cartridge is improperly set.
See 8.1.2 "Replacing the Toner Cartridges"
There is not enough memory available for the printer to function
normally.
Action:
Press the <Form Feed/Set> button and cancel printing. Install a
memory expansion card and reprint.
See Appendix A.5 "Adding the Expansion Memory".
If you are unable to install a memory expansion card, print after
configuring the printer driver as follows:
• Turn off the Duplex Printing and Multiple Page setting.
• Change the setting in 'Document Types' to 'Normal' in the
"Graphics" tab (Windows), or the "General" dialog box
(Macintosh). Note that this lowers image quality.
See "Help"
6-21
Advertisement
Table of Contents
