Remote Control Unit Operations; Main Remote Control Unit (Rc-1099); Operating Denon Audio Components; Presetting - Denon AVR 1909 - AV Receiver Owner's Manual

ENGLISH

Remote Control Unit Operations

Main Remote Control Unit
(RC-1099)
[Front]
[SOURCE
CONTROL 1]
[Rear]
[ZONE2 OFF]
[NUMBER]
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.


Operating DENON Audio Components

1
[SOURCE CONTROL 1]
Set
2
[SOURCE CONTROL 2]
Set
component to be operated (CD, iPod/NETWORK or
TUNER).
3
Operate the audio component.
[SOURCE
CONTROL 2]
b For details, refer to the component's operating instructions.
b While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.

Presetting

• DENON and other makes of components can be operated by
setting the preset memory.
• Operation is not possible for some models.
[MAIN ON]
1
[SOURCE CONTROL 1]
Set
b Set to the AUDIO side for the CD position, and to the VIDEO side
for the DVD/HDP, VCR, SAT/CABLE or TV position.
2
[SOURCE CONTROL 2]
Set
registered.
3
[ZONE2 OFF]
P ress
The indicator starts flashing.
4
[NUMBER]
Press
brand of the component to be preset. The numbers
are shown in the Preset Code Table (vEnd of this
manual).
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
to "AUDIO".
to the position for the
to "AUDIO" or "VIDEO".
to the component to be
[MAIN ON]
and at the same time.
and input the 3-digit number of the
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset
memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: DVD/HDP and SAT/CABLE.
• VDP (Video Disc Player) can be preset when
is set to "DVD/HDP".

Operating Preset Components

1
[SOURCE CONTROL 1]
Set to "AUDIO" or "VIDEO".
b Set to the AUDIO side for the CD position, and to the VIDEO side
for the DVD/HDP, VCR, SAT/CABLE or TV position.
2
[SOURCE CONTROL 2]
Set to the component you want
to operate.
3
Operate the component.
b For details, refer to the component's operating instructions.
b Some models cannot be operated with this remote control unit.
[SOURCE CONTROL 2]