Channel Level; Fader Function - Denon AVR 1909 - AV Receiver Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SPEAKERS>
<INPUT MODE>
<POWER> QUICK SELECT
QUICK SELECT
[Front]
uiop
[Rear]
uiop

Operations
1
Connect the HDMI to the AVR-1909 with equipment
compatible with the HDMI control function (vpage
BUTTON
62).
<BUTTON>
[BUTTON]
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
ui
b Please consult the operating instructions for the connected
equipment to check the settings.
b Steps 1~3 do not have to be repeated once started.
b Carryout steps 2 and 3 should any of the equipment be plugged
out.
4
Switch the television input to the HDMI connected to
the AVR-1909.
5
Switch the AVR-1909 input to the HDMI input source
<SELECT/ENTER>,
and check if the picture from the player is ok.
op
6
Put the television power on standby and check if the
AVR-1909 goes into standby.
If the AVR-1909 does not work please check the following.
• Is the menu "Manual Setup" – "HDMI Setup" – "HDMI Control"
(vpage 32) set to "ON"?
• Is the menu "Manual Setup" – "HDMI Setup" – "Power Off Control"
(vpage 32) set to "ON"?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
[CH SELECT/
• Should any of the operations below be performed, the interlocking
ENTER]
function may be reset, in which case, repeat step's 2 and 3.
Menu "Input Setup" – "Assign" – "HDMI In" (vpage 42) setting
•
has changed.
There is a change to the connection between the equipment and
•
the HDMI, or an increase in equipment.
NOTE
When you power off AVR-1909, the HDMI control function does not
operate. Either power on or set to standby.
[CH SELECT/
ENTER]

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
<SELECT/ENTER> [CH SELECT / ENTER]
Press or
Channel Volume
FL 0.0dB SR
C 0.0dB SBR
FR 0.0dB SBL
SW 0.0dB SL
Fader
FRONT : REAR
2
<SELECT/ENTER> [CH SELECT / ENTER]
Use ui, or
to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b In the case of a subwoofer, reducing the volume when it is at "–12
dB" will change the setting to "OFF" (none).
NOTE
When the input source is "iPod" , you cannot perform channel level
setting.

Fader Function

This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1
<SELECT/ENTER> [CH SELECT / ENTER]
Press or
2
<SELECT/ENTER>
Press ui,
ENTER]
to select "Fader".
3
Use o p to adjust the volume of the speakers.
(o: front, p: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
.
0.0dB
0.0dB
0.0dB
0.0dB
.
[CH SELECT /
or