Installing And Removing A Hot-Swap Hard Drive; Installing A Sas Or Sata Hot-Swap Hard Disk Drive - Intel SR1690WB - Server System - 0 MB RAM Service Manual

3. Remove the AC power cord from the server.
4. Remove the server's cover.
5. Unplug the processor fan cable from the server board.
6. Loosen the four captive screws on the corners of the heat sink.
7. Twist the heat sink slightly to break the seal between the heat sink and the
processor.
8. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink
again. Do not force the heat sink from the processor. Doing so could damage the
processor.
9. Lift the processor lever.
10. Raise the CPU load plate.
11. Remove the processor.
12. If installing a replacement processor, see
install the protective socket cover over the empty processor socket and reinstall the
chassis cover.

Installing and Removing a Hot-swap Hard Drive

You can install up to two fixed SATA drives in the Intel
Service Guide. See
Caution: If you install less than four drives or devices, the empty drive bays must be occupied by
carriers with drive blanks to maintain proper system cooling.
To avoid possible damage to your server system, use only the drive carriers that came
with your system.

Installing a SAS or SATA Hot-swap Hard Disk Drive

Note: The server system does not support all hard drives. See "Server System References" for a
link to a list of supported hardware.
1. Open the latch at the front of the hard drive carrier (see letter "A").
2. Pull out on the black lever and slide the carrier from the server system (see letter
"B").
®
Intel Server System SR1690WB Service Guide
"Server System References"
"Installing the Processor". Otherwise,
®
Server System SR16WB90
for a link to a list of supported hardware.
35