Installing And Removing A Hot-Swap Hard Drive (Sr2520Sax/Sr2520Saxs And Sr2520Saxr/Sr2520Saxsr); Installing A Sas Or Sata Hot-Swap Hard Disk Drive (Sr2520Sax/Sr2520Saxs And Sr2520Saxr/Sr2520Saxsr) - Intel SR2520SAFRNA - Server System - 0 MB RAM User Manual

9. Raise the CPU load plate.
10. Remove the processor.
11. If installing a replacement processor, see
install the protective socket cover over the empty processor socket and reinstall the
system's cover.
Installing and Removing a Hot-swap Hard Drive
(SR2520SAX/SR2520SAXS and SR2520SAXR/
SR2520SAXSR)
Up to six hot-swap SATA drives or SAS drives can be installed.
Cautions: If you install less than six drives or devices, the empty drive bays must be occupied by
carriers with baffles to maintain proper system cooling.
To avoid possible damage to your server system, do not use older style drive carriers.
Note: The server system does not support all hard drives. See
an Internet link to a list of supported hardware.
Installing a SAS or SATA Hot-swap Hard Disk Drive
(SR2520SAX/SR2520SAXS and SR2520SAXR/
SR2520SAXSR)
1. Remove the front bezel if it is installed. For instructions, see
Bezel".
2. Open the green latch at the front of the hard drive carrier.
3. Pull out on the black lever and slide the carrier from the server system.
®
Intel Server System SR2520SA User's Guide
"Installing the Processor". Otherwise,
"Server System References"
"Removing the Front
for
37