Installing And Removing A Hot-Swap Hard Drive; Installing A Sas Or Sata Hot-Swap Hard Disk Drive; Figure 29. Removing Hot-Swap Disk Carrier From The Server System; Figure 30. Removing Drive Blank From Drive Carrier - Intel SR1560SF - Server System - 0 MB RAM Service Manual

Installing and Removing a Hot-swap Hard Drive

Up to three hot-swap SAS or SATA drives can be installed in the Intel
SR1560SF - product code SR1560SFHS.
Cautions: If you install less than three drives or devices, the empty drive bays must be occupied by
carriers with drive blanks to maintain proper system cooling.
To avoid possible damage to your server system, use only the drive carriers that came
with your system.
Note: See "Server System References"

Installing a SAS or SATA Hot-swap Hard Disk Drive

1. Open the latch at the front of the hard drive carrier (see letter "A").
2. Pull out on the black lever and slide the carrier from the server system (see letter
"B").

Figure 29. Removing Hot-swap Disk Carrier from the Server System

3. Remove the four screws that attach the plastic retention device or the previously
installed hard drive to the drive carrier (see letter "A"). Two screws are at each side
of the retention device or the hard drive. Remove the drive blank (see letter "B")
and store it for future use.
32
for an Internet link to a list of supported hardware.
A

Figure 30. Removing Drive Blank from Drive Carrier

B
A
TP02206
B
TP02207
®
Intel Server System SR1560SF Service Guide
®
Server System