Mute; Cordless Handset; Do Not Disturb; Flash - RCA 25255RE2 - ViSYS Cordless Phone Base Station User Manual

To switch to the headset, press the headset button to enable the headset, and the
headset indicator illuminates.

Cordless Handset

To switch to the speakerphone, press Spk button.
If the headset is plug in, press Talk button to switch to headset.
If the headset is not plug in, press Talk button to switch to cordless handset's receiver.

Mute

To have a private, off-line conversation, use the Mute feature. The party on the other end
of the line cannot hear you, but you can still hear them.
1. Press mute button to activate the mute feature.
NOTE: When using the mute feature on the base, the indicator will illuminate
when the mute is activated.
2. Press the mute button again to de-activate.

Do Not Disturb

This feature is set at individual telephones to disable (silence) an incoming ring signal,
intercom ring. When there is an incoming call or an intercom call, the status indicators
function as normal but the phone will not ring.
1. When the unit is idle, press the DND/privacy button. The last setting is displayed.
2. Use the VOL (- or +) button to select the duration. You may choose from 15 minutes, 30
minutes, 45 minutes, 1 hour, or 2 hours and increase the duration by 1-hour intervals
up to 24 hours.
3. Press the SELECT Soft key to confirm. The indicator (on the base) blinks and the display
shows how long the ringer will be disabled.
4. To cancel, press DND/privacy button again.

Flash

If you subscribe to Call Waiting Caller ID service from your local telephone company and
you receive an incoming call during a call, you will hear a beep to indicate another call is
waiting on the line and Caller ID information (if available) for the waiting call shows on the
display.
• To connect to the waiting call, press the menu/flash button on the handset or the
flash button on the base, and your original call is put on hold.
• To switch between the two calls, press the menu/flash (Handset) or flash (base)
button.

Inserting a Pause in the Dialing Sequence

Press the #pause button twice to insert a delay in dialing sequence when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an outside line, or to wait for
a computer access tone.) Each pause counts as one digit in the dialing sequence, and is
shown as "P" in the display.
28