Installing The Phone; Installing The Handset Battery - RCA 25255RE2 - ViSYS Cordless Phone Base Station User Manual

Installing the Phone

Installing the Handset Battery

NOTE: You must connect the handset battery before use.
CAUTION: To reduce the risk of fire or personal injury, use only the Telefield NA Inc.
Inc. approved Nickel-metal Hydride (Ni-MH) battery Model T-2734, which is
compatible with this unit.
1. Locate battery which is packaged inside a plastic bag and is separate from the
handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: To ensure proper battery installation, the connector is keyed and can be
inserted only one way.
4. Insert the battery pack.
5. Close the battery compartment by placing the handset back cover slightly higher than
the handset and then sliding the cover down into position.
6. Place cordless handset in remote charger. The charge indicator illuminates, verifying
the battery is charging.
7. Allow the phone to charge for 14 hours prior to first use. If you don't properly charge
the phone, battery performance is compromised.
NOTE: If the model you bought is a RE2 version, there is one additional charger.
Plug the power supply cord into the power jack on the back of the charger and
the other end into an electrical outlet. Place handset in the charger, the charge
indicator illuminates, verifying the battery is charging.
CAUTION: To reduce risk of personal injury, fire, or damage use only the
T-8BXD (charger) power adaptor listed in the user's guide. This power
adaptor is intended to be correctly orientated in a vertical or floor mount
position.
PRESS DOWN FIRMLY
RED WIRE
BATTERY
BLACK WIRE
11