Configuring The Time Settings - Cisco QuickVPN - PC Administration Manual

Administration

Configuring the Time Settings

Configuring the Time Settings
STEP 1
STEP 2
STEP 3
Cisco SA 500 Series Security Appliances Administration Guide
• Incoming Traffic Volume: The volume of traffic, in Megabytes, that was
downloaded through this interface.
• Total Traffic Volume: The amount of traffic, in Megabytes, that passed
through this interface in both directions.
• Average per day: The average volume of traffic that passed through this
interface.
• % of Standard Limit: The amount of traffic, in percent that passed through
this interface against the Monthly Limit.
• % of Monthly Limit: The amount of traffic, in percent that passed through
this interface against this Month's Limit (if the month's limit has been
increased).
You can configure your time zone, whether or not to adjust for Daylight Savings
Time, and with which Network Time Protocol (NTP) server to synchronize the date
and time. The security appliance then gets its date and time information from the
NTP server. Please follow the steps below to configure NTP and time settings:
Click Administration on the menu bar, and then click Time Zone in the navigation
tree.
The Time Zone page appears.
Enter the following information:
• Date/Time: Choose the time zone relative to Greenwich Mean Time (GMT).
• Automatically Adjust for Daylight Savings Time: Check this box if you want
the time to be automatically adjusted for Daylight Savings Time.
• Use Default NTP Servers or Use Custom NTP Servers: You can use the
default Network Time Protocol (NTP) servers, or you can enter the IP
addresses of up to two custom NTP servers.
Click Apply to save your settings, or click Reset to revert to the saved settings.
9
207