Configuring A Port Triggering Rule To Direct Traffic To Specified Ports - Cisco QuickVPN - PC Administration Manual

Firewall Configuration
Port Triggering
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco SA 500 Series Security Appliances Administration Guide
Port triggering is not appropriate for servers on the LAN, since the LAN device must
make an outgoing connection before an incoming port is opened.
Configuring a Port Triggering Rule to Direct Traffic to
Specified Ports
Click Firewall on the menu bar, and then click Port Triggering > Port Triggering in
the navigation tree. The Port Triggering page appears.
The Port Triggering page appears. Any existing rules are listed in the List of
Available Port Triggering Rules table.
To add a new port triggering rule, click Add.
Other options: Click the Edit button to edit an entry. To delete an entry, check
NOTE
the box and then click Delete. To select all entries, check the box in the first
column of the table heading.
After you click Add or Edit, the Port Triggering Configuration page appears.
In the Port Triggering Rule area, enter the following information:
• Name: Enter a name for this rule.
• Enable: Check this box to enable this rule.
• Protocol: Choose the protocol.
In the Outgoing (Trigger) Port Range area, enter the Start Port and End Port to
specify the outgoing port range for this rule.
In the Incoming (Response) Port Range area, enter the Start Port and End Port to
specify the incoming port range for this rule.
Click Apply to save your settings, or click Reset to revert to the saved settings.
5
140