Vehicle Electronics - Dodge 2007 Sprinter Owner's Manual

Vehicle electronics

Vehicle electronics
Tampering with the engine electron-
ics
!
Work on the engine electronics and all
associated parts such as control units,
sensors and connector leads should
only be performed at an authorized
Sprinter Dealer. Vehicle parts could
otherwise wear more quickly and the
vehicle's warranty or general operating
permit could be invalidated.
Warning
6
For safety reasons and to avoid invalidating
the general operating permit, always have
work on the engine electronics and associ-
ated parts performed at an authorized
Sprinter Dealer which has the necessary
specialist knowledge and tools to carry out
the work required.
The manufacturer recommends that you use
an authorized Sprinter Dealer for this pur-
pose. In particular, work relevant to safety
or on safety-related systems must be car-
ried out at an authorized Sprinter Dealer.
Retrofitting electrical/electronic
equipment
Electrical and electronic equipment can
jeopardize the operational safety of your
vehicle. If equipment of this kind is retrofit-
ted, it must be type-approved and must
bear the e mark.
G
If you wish to install telephones or two-way
radios in the vehicle, you must obtain for-
mal approval.
The manufacturer recommends that you
consult an authorized Sprinter Dealer.
You may retrofit telephones and two-way
radios provided that the maximum trans-
mission outputs listed below are not
exceeded. Always have this type of equip-
ment professionally installed with an exte-
rior antenna which has been installed in
such a way as to be reflection-free.
Frequency range Maximum trans-
mission output
Short wave
(< 50 MHz)
4 m waveband
2 m waveband
70 cm waveband
25 cm waveband
.
!
If electrical or electronic equipment
which does not fulfill these conditions
is retrofitted, the vehicle's general
operating permit may be invalidated.
100 W
20 W
50 W
35 W
10 W