Dodge 2007 Sprinter Owner's Manual page 334

Then press 0 on electric air pump
switch 1.
The electric air pump is switched off.
i
The tire sealant is water soluble. If tire
sealant escapes, you can wash it away
with water.
Screw the valve cap onto tire valve b.
After filling with tire sealant
( page 333).
After filling with tire sealant
Turn the pressure release screw on
pressure gauge 5 counterclockwise
and bleed the system.
Turn the key to position 0 in the igni-
tion lock ( page 67).
Pull the electric air pump connector out
of the 12 V socket.
Store the electric air pump, tire sealant
bottle 8 with valve core extractor c
and, if used, the warning triangle and
hazard warning lamps inside the vehi-
cle.
Unscrew and remove angle bracket 2
from valve 7 on tire sealant bottle 8
and screw the valve cap onto the valve.
Warning
Do not exceed the maximum speed of
50 mph (80 km/h).
The "max. 50 mph (80 km/h)" sticker must
be affixed within the driver's field of vision.
The vehicle's handling characteristics may
be affected.
Pull away immediately.
This enables the tire sealant to distrib-
ute inside the tire and create a more ef-
fective seal.
Stop after about 3 minutes and check
the tire pressure using the electric air
pump, for example.
i
You must connect the angle bracket on
hose 3 of the electric air pump direct-
ly to the tire valve on the tire.
Correct the tire pressure accordingly if
it does not correspond to the recom-
mended tire pressure (
Increasing the tire pressure
G
Switch on the electric air pump.
Reducing the tire pressure
Open the pressure release screw
on pressure gauge 5.
Drive to the nearest workshop and
have the tire repaired or replaced.
Clean the valve core extractor using
clean water.
Have tire sealant bottle 8 replaced as
soon as possible at an authorized
Sprinter Dealer.
Flat tire
page 210).
5