Dodge 2007 Sprinter Owner's Manual page 329

Flat tire
Tire sealant bottle for twin tires
7 Valve
8 Tire sealant bottle with hook, hose and
5
angle brackets
Shake tire sealant bottle 8.
Unscrew and remove the cap from
valve 7 on tire sealant bottle 8.
Press angle bracket 2 (
on hose 3 of the electric air pump all
the way onto valve 7 of tire sealant
bottle 8 and clamp it in place.
The following steps may vary depending on
vehicle tires.
Single tires (
Twin tires, inner wheel (
Twin tires, outer wheel (
Single tire
page 327) 9 Hook
a Knob
b Lever
c Valve core extractor
d Tire valve
page 328).
page 329)
page 331)
Pull knob a out of valve core extractor
c as far as the stop.
Unscrew and remove the valve cap
from tire valve d on the flat tire.
Hook the tire sealant bottle into the up-
per vent hole in the wheel using
hook 9.
Keep lever b pressed, connect valve
core extractor c firmly to tire valve d
and release lever b.
Press knob a into the valve core of
tire valve d, turning it gently as you do
so, until the shaft of valve core
extractor c engages.
Turn knob a counterclockwise until
the valve core is unscrewed.
Pull knob a out of valve core extractor
c as far as the stop.
This pulls the valve core into the valve
core extractor and seals it against the
valve core extractor stop.
Make sure that the pressure release
screw on pressure gauge 5 is closed.
Connect connector 6 to the 12 V
socket (12 V, 25 A, 300 watts) on the
center console ( page 170).