Aimer Delay; User-Specified Aimer Delay; Aimer Mode - Honeywell 4820HDHM User Manual

Aimer Delay

The aimer delay allows a delay time for the operator to aim the image scanner
before the picture is taken. Use these codes to set the time between when the
trigger is pulled and when the picture is taken. During the delay time, the
aiming light will appear, but the LEDs won't turn on until the delay time is over.
Default = Off.
200 milliseconds
400 milliseconds
* Off
(no delay)

User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart inside the back cover of this manual, then scan Save.
Delay Duration

Aimer Mode

This feature allows you to turn the aimer on and off. When the Interlaced
barcode is scanned, the aimer is interlaced with the illumination LEDs. Default
= Interlaced.
Off
* Interlaced
4 - 12