User-Specified Reread Delay; Led Power Level - Honeywell 4820HDHM User Manual

Use shorter delays in applications where repetitive barcode scanning is
required. Reread Delay only works when in
Default = Medium.
Short (500 ms)
Long (1000 ms)

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
inside back cover, then scanning Save.

LED Power Level

This selection allows you to adjust LED and aimer brightness. Off is used when
no illumination is needed. Low is used if low illumination is sufficient. High (the
default) is the brightest setting.
4 - 10
User-Specified Reread Delay
Presentation Mode
* Medium (750 ms)
Extra Long (2000 ms) Extra Long (2000 ms)
(see page 4-7).