DAELIM HISTORY 125 Service Manual page 134

FRONT WHEEL/FRONT FORK/STEERING
● Clean the throttle grip sliding surface.
● Apply grease to the throttle grip sliding surface and
install the throttle grip.
● Apply grease to the throttle cable ends and connect the
throttle cable to the groove of the grip.
● Tighten the pan screw after assembling the under and
upper throttle housings.
NOTE
·Check that the throttle grip moves smoothly.
·Adjust the throttle grip free play. (⇨3-4 )
● Apply DAELIM Bond A to the inside surface of the
grip and to the clean surface of the left handle bar. Wait
3~6 minutes and install the grip.
(Bond A :ROYAL BOND 1300)
NOTE
·Clean the bonding surface to avoid oil, grease or
gasoline from attaching.
·Leave it for minimum 1 hour until the bond is dried.
·Use the bond according to the bond manual enclosed
and install the grip while rotating it before the bond is
dried completely.
● Install the front / rear brake master cylinders by
aligning the punch mark on the handlebar with the
master cylinder and set the master cylinder holder with
the "UP" mark facing up or punch mark facing
forward or up.
12-4
PAN SCREW
THROTTLE HOUSING
MASTER CYLINDER
PUNCH MARK
SETTING BOLT
THROTTLE GRIP