Uninstalling The Power Scheme Agent; Collecting Power Scheme Inventory Data - Symantec ALTIRIS CLIENT MANAGEMENT SUITE 7.0 SP2 - V1.0 Manual

18 Using Power Scheme Task

Collecting power scheme inventory data

Uninstalling the Power Scheme Agent

Collecting power scheme inventory data
If you do not perform the power scheme management tasks on your computers
over an extended period of time, you can uninstall the Power Scheme Agent.
Uninstalling the unused agents helps to eliminate the unnecessary network traffic.
To uninstall the Power Scheme Agent, you must turn on the uninstall policy.
Note: Before you uninstall the Power Scheme Agent, make sure that you turn off
the Power Scheme Agent Install policy.
See "About Power Scheme Task component"
See "Installing the Power Scheme Agent"
To uninstall the Power Scheme Agent
1 In the Symantec Management Console, on the Actions menu, click
Agents/Plug-ins > Rollout Agents/Plug-ins.
2 In the left pane, click Power Scheme > Power Scheme Agent Uninstall.
3 In the right pane, make any wanted changes.
For more information about policy configuration options, press F1 or click
Help > Context.
4 Turn on the policy.
At the upper right of the page, click the colored circle, and then click On.
5 Click Save changes.
The Power Scheme Inventory task lets you collect power scheme settings inventory
from managed computers.
See "About Power Scheme Task component"
To perform this task, you must install the Power Scheme Agent on the target
computers.
See "Installing the Power Scheme Agent"
After you run the inventory task, you can use the predefined report to view the
collected power scheme settings data.
See "Viewing power scheme inventory data"
on page 15.
on page 17.
on page 15.
on page 17.
on page 20.