Specifications - Dixon 2004 Operator's Manual

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM: Electric by key switch operation with safety interlocks on
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
14
S P E C I F I C A T I O N S
ZEETER 30"
11 gauge welded channel frame
All body parts made of rotational molded polyethylene.
Front body contains access panel for battery service.
Seat tilts forward to allow transmission service.
11 GA stamped steel construction. Single 30" cut blade.
Cut height approximately 1-1/2"- 4" via 7-position lift handle.
Mechanical; hand lever engagement
Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
9 HP Briggs & Stratton Powerbuilt, 4-cycle, single
cylinder, air-cooled, gasoline, vertical shaft, aluminum
head and block.
parking brake and blade drive.
Front 9 x 3.50-4 Turf Saver
Rear 16 x 6.50-8 Turf Saver
Front 16-21 PSI
Rear 8-14 PSI
Fuel 3 quart
Engine 1.25 quarts oil
Width 32" outside rear wheel measurement
Width 38" overall width of deck with deflector
Height 31" to top edge of seat
Length 65.5" hitch tab to front
Weight 390 lbs.