Table of Contents
Advertisement
If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation."
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the server cover, place the cover-release latch in the open (up)
2. Install the server in a rack. See the Rack Installation Instructions that come with
3. Connect the cables and power cords. See "Connecting the cables" on page 48
a. Make sure that the microprocessor-tray release latch is open; then, push
the microprocessor tray into the server.
b. Close the tray levers and make sure that they are securely latched.
c. Press the microprocessor-tray release latch down.
d. Reinstall the fans and memory cards in the server.
position. Insert the bottom tabs of the top cover into the matching slots in the
server chassis. Press down on the cover-release latch to lock the cover in
place. Replace the bezel, if you removed it.
Top cover
Bezel
the server for complete rack installation and removal instructions.
Attention:
v Install the server only in a rack cabinet with perforated doors.
v Do not leave open spaces above or below an installed server in the rack
cabinet. To help prevent damage to server components, always install a blank
filler panel to cover the open space and to help ensure proper air circulation.
See the documentation that comes with your rack cabinet for more
information.
for more information.
Cover release
latch
Chapter 2. Installing options
47
Advertisement
Table of Contents
