Table of Contents
Advertisement
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces
Removing the cover and bezel
To remove the cover and bezel, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you are installing or replacing a non-hot-swap component, turn off the server
3. Slide the server out of the rack until the slide rails lock into place.
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the two tabs at the bottom edge of the bezel.
Installing a hot-swap power supply
The following notes describe information that you must consider when installing a
hot-swap power supply in the server:
v The server comes with a minimum of one power supply and supports up to two
metal part on the outside of the server for at least 2 seconds. This drains static
electricity from the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
indoor humidity and increases static electricity.
on page 21.
and all attached peripheral devices. Disconnect all power cords; then,
disconnect all external signal cables from the server.
Top cover
Bezel
(0.5 inch). Lift the cover off the server.
Attention:
For proper cooling and airflow, replace the top cover before
turning on the server. Operating the server for more than 2 minutes with the top
cover removed might damage server components.
of the bezel slightly away from the server.
power supplies (hot-swappable at 220 V ac only).
Cover release
latch
Chapter 2. Installing options
23
Advertisement
Table of Contents
