Table of Contents
Advertisement
Using the SAS/SATA Configuration Utility program
Use the SAS/SATA Configuration Utility program to configure SAS devices.
Starting the SAS/SATA Configuration Utility program
To start the SAS/SATA Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt <<< Press <CTRL><A> for Adaptec SAS/SATA Configuration
3. To select a choice from the menu, use the arrow keys.
4. Follow the instructions on the screen to change the SerialSelect Utility or Disk
SerialSelect Utility menu choices
The following choices are on the SerialSelect Utility menu:
v SAS Controller Configuration
v PHY Configuration
Disk Utilities
Select this choice to format, verify, or locate SAS devices. Select a device from the
list and read the instructions on the screen carefully before making a selection.
Using ServeRAID Manager
Use ServeRAID Manager, which is on the IBM ServeRAID Support CD, to:
v Configure a redundant array of independent disks (RAID) array
v Restore a SCSI hard disk drive to the factory-default settings, erasing all data
v View the RAID configuration and associated devices
v Monitor the operation of the RAID controllers
– power
Turn the server on and off remotely.
– reboot
Force the server to restart.
– sel get
Display the BMC system event log.
– sol
Configure the SOL function.
– sysinfo
Display system information that is related to the server and the globally
unique identifier (GUID).
Utility! >>> appears, press Ctrl+A.
Utilities settings.
Select this choice to view or change SAS controller settings. To reset the
controller to its default settings, press F6 and follow the instructions on the
screen.
Select this choice to view or change PHY configuration settings. To reset the
controller to its default settings, press F6 and follow the instructions on the
screen.
from the disk
Chapter 3. Configuring the server
79
Advertisement
Table of Contents
