Adjusting The Thread Wiper; Presser Foot Installation Position - Brother BAS-300G Instruction Manual

Direct drive programmable electronic pattern sewer

Hide thumbs Also See for BAS-300G:

Table of Contents

10. STANDARD ADJUSTMENTS

10-12. Adjusting the thread wiper

5007Q

1. Loosen the two screws (3) and shift the entire solenoid setting plate (4) up or down to adjust so that the thread wiper (2) is

15 mm in front of the needle center when the plunger (1) of the thread wiper solenoid is driven to the full stroke.

2. Loosen the screw (5) and adjust the position of the thread wiper (2) so that the distance from the thread wiper to the tip of

the needle is approximately 2 mm and the tip of the thread wiper (2) is approximately 3 mm from the center of the needle

when the thread wiper (2) passes below the needle during operation.

Note: Check that the thread wiper (2) does not touch the finger guard.

Install the presser foot (1) with the screw (2) so that the

distance from the bottom of the presser foot to the top of the

needle plate is 22 mm when the sewing machine is stopped

and the presser foot (1) is raised.

5031Q

BAS-300G, BAS-311G, BAS-326G

Approx. 3mm

5008Q

Approx. 2mm

5009Q

Table of Contents

Show Quick Links

Table of Contents

Bas-311g Bas-326g