List Of Memory Switch Settings - Brother BAS-300G Instruction Manual

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6-3. List of memory switch settings

Setting
No.
range
Work clamp lift timing after sewing is completed
001
OFF
ON
Separate-type work clamp drop operation (pneumatic work clamp specifications)
0
002
1
2
Work clamp drop operation (motor-driven work clamp specifications)
0
003
1
2
Sewing start speed
OFF
100
ON
Single-stitch test feed
OFF
200
ON
Production counter display
300
OFF
ON
User programs
400 OFF
ON
Cycle programs
401 OFF
ON
Maximum reduction ratio (mm display) (*)
402
OFF
ON
Split mode selection
0
403
1
2
* The mm display may differ slightly from the actual sewing size.
35
Lifts at the final stitch position.
Lifts after moving to the sewing start position.
Left and right work clamp drop at the same time.
Work clamp drops in the order left → right.
Work clamp drops in the order right → left.
Analog dropping: Work clamp drops in direct proportion to the pedal depression
amount, and sewing starts when the pedal is fully depressed
1st step drop: Work clamp drops when the pedal is depressed to the 1st step, and
sewing starts when the pedal is depressed to the 2nd step
2nd step drop: Work clamp drops to intermediate height when the pedal is
depressed to the 1st step, and work clamp drops and sewing starts when the
pedal is depressed to the 2nd step.
The sewing speed for the first 1 − 5 stitches is set by memory switch numbers 151
− 155.
(Refer to the service manual for details of memory switch Nos. 151 − 155.)
1st stitch at 400 sti/min, 2nd stitch at 400 sti/min, 3rd stitch at 600 sti/min, 4th
stitch at 900 sti/min, 5th stitch at 2,000 sti/min
Test feed starts when the foot switch (start switch) is depressed, and it continues
automatically until the final stitch.
Test feed is carried out one stitch at a time when the foot switch (start switch) is
depressed (feed becomes continuous if the foot switch [start switch] is
continuously depressed).
In addition, when the TEST indicator is illuminated, test feeding will move forward
one stitch at a time when the machine pulley is turned by hand.
Lower thread counter display
Production counter display
Disabled
User program mode is enabled.
Disabled
When sewing user programs, the set programs are sewn in numeric order.
Displayed as %.
Displayed as mm.
Continuous split (split menu is disabled before split detection)
Continuous split (split menu is always enabled)
Independent split
BAS-300G, BAS-311G, BAS-326G
Setting items Initial value
ON
0
2
OFF
OFF
OFF
OFF
OFF
OFF
0