Reading All Sewing Data From The Cf Card At Once - Brother BAS-300G Instruction Manual

7. USING CF CARDS
*1 The sewing data that can be used with this sewing machine is data that has been created for the BAS-300G series.
*2 Only valid when using an optional floppy disk drive.
*3 Sewing data for the BAS-300 series, BAS-300A series and BAS-300E/F series can be read.
*4 Refer to the instruction manual for the programmer for details of expansion option output.
*5 Can be selected when memory switch No. 755 = ON.
Save the expansion option output data (BAS900.SEQ) in the \BROTHER\ISM\ISMDB00 folder.

7-3-1. Reading all sewing data from the CF card at once

1
2
3
4
End data read/write mode
49
Loading
TEST indicator switches off
BAS-300G, BAS-311G, BAS-326G
Select the [r 1] data read/write mode.
Press the R/W key.
• [-SEd] will change to [ ALL].
* If you press the or
numbers that you would like to read and then continue
to carry out the following procedure, you can read the
selected sewing data in separate lots.
Press the R/W key.
• The buzzer will sound and all sewing data will be
loaded from the CF card and copied into the sewing
machine's internal memory.
• The program numbers that have been read will appear
in the menu display.
* If there is a large volume of data in the CF card, it will
take some time for all of it to be read. To halt the
reading of data, press the STOP switch. If you then
press the RESET key, the display will change back to
[ ALL].
Press the TEST key.
Turn off the power switch, remove the CF card, and then
close the cover of the CF slot.
4576Q
key to select the program
4577Q
4976Q