Table of Contents
Advertisement
3
<Changing modes>
4
Ending setting mode
THREAD/CLAMP indicator switches off
Intermittent presser foot operation
During standby
When lowered
While sewing
5033Q
Press the
The sewing machine will switch to intermittent presser foot height
setting mode.
• " 4" will appear in the PROGRAM No. display, and the work
clamp will rise to the setting value that appears in the menu
display.
(Intermittent presser foot height setting: 0.0 − 10.0)
Press the
height.
• The intermittent presser foot will rise or drop to the height of
the new value that has been set.
NOTE:
Motor-driven work clamp specifications
"
1" Threading mode
↑ ↓
"
2" Work clamp height setting mode
↑ ↓
"
3" Intermediate work clamp height setting mode (*)
↑ ↓
"
4" Intermittent presser foot height setting mode
Pneumatic work clamp specifications
"
1" Threading mode
↑ ↓
"
4" Intermittent presser foot height setting mode
Press the THREAD/CLAMP key.
• The setting values will be memorized.
• The work clamp will return to where it was before setting mode
was started.
BAS-300G, BAS-311G, BAS-326G
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
key.
or
key to set the intermittent presser foot
After making the setting, be sure to turn the pulley once by
hand and check that the
touch the needle bar.
* When memory switch No. 003 is set to "2"
1
Intermittent presser foot lift amount
2
Intermittent presser foot height
The settings can be made by the above
operations.
However, set the intermittent presser foot
height to a higher setting than the
intermittent stroke.
* If it is set smaller, the intermittent presser
foot will come into contact with the
needle plate.
3
Intermittent stroke
Refer to "10-14. Changing the intermittent
stroke" when making the adjustment.
intermittent
presser foot does not
5225Q
4448Q
32
Hide quick links:
Advertisement
Table of Contents
