Server Configuration And Utilities; Using Compaq Smartstart - Compaq ProLiant 5500 Setup And Installation Manual

Chapter 5
Server Configuration and
Utilities

Using Compaq SmartStart

SmartStart is the intelligent way to configure the server and to load the system
software, thereby achieving a well-integrated server to ensure maximum
dependability and supportability. To use the SmartStart and Support Software
CD, refer to the Server Setup and Management pack. The first time the server is
configured, the SmartStart program automatically creates a system partition and
installs the Compaq System Configuration Utility and other Compaq utilities in
that partition.
NOTE: Until you run the System Configuration program, an information
message indicating that you are running with a default configuration will occur
each time you boot the system.
To install the SmartStart and Support Software CD:
1. With your computer turned on, locate the CD-ROM drive.
2. Open the CD-ROM tray by pressing the load/unload button.
Figure 5-1. Installing a CD in the CD-ROM drive
For use with Intel Pentium II Xeon processor-based servers only
Compaq ProLiant 5500 Servers Setup and Installation Guide
5-1