Table of Contents
Advertisement
7. Click OPEN+LOAD(L) button and load EV2 data.
EV2 data: CF102_PAL_DATA_ver100.ev2
8. The EV2 data will be stored in EEPROM (address
0000-07FF).
(Data are just example)
Note: If "SLAVE-ADDRESS Receiver Error" appears, click
Option (O) and change "WAIT" valume within the limit of
from 20 up to 250. Then excute item-7 and 8 again.
<About the other Button Functions>
8 If you click READ(R) button, you can confirm the
setup data.
8 If you click READ+SAVE(S) button, you can save the
data of the Camera.
8 If you click RESET(P) button, it is same meaning of
power reset.
8 If you click END(Z) button, you can finish the EVR
Adjustment.
8 GRID(G) button is not used for adjustment.
4.2.3. Adjustment Procedure
1. Click Adjust(A) to open adjustment menu and select
"Adjust".
2. Select each item from the menu, press ENTER key of the
Personal Computer or click the white colour Button on
the right side of the Adjustment menu and perform each
adjustment.
3. Press ARROW keys M< of the Personal Computer to
change the Current Data or input the data into New Data
box. Then press ENTER key of the Personal Computer.
(Data are example of the fsc Adjustment)
4. In order to go next step, click ESC button or press the
ENTER key of the Personal Computer.
The adjusted data is stored.
5. When finished the adjustment, click END(Z) button.
2-7
Advertisement
Table of Contents
