Table of Contents
Advertisement
110
Parameter
Password on
boot
Fixed disk
boot sector
Diskette access
To set a Supervisor/User password
1
Use the up/down keys to highlight a password parameter
(Supervisor Password or User Password) then press Enter.
A password box will appear.
2
Type a password then press Enter.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3
Retype the password to verify the first entry then press Enter
again.
After setting the password, the system automatically sets the
chosen password parameter to Installed.
To change the Supervisor/User password
1
Use the up/down keys to highlight either change password
parameters (Change Supervisor Password or Change User
Password) then press Enter.
2
Type the original password then press Enter.
3
Type a new password then press Enter.
4
Retype the password to verify the first entry then press Enter
again.
To remove the User password
1
Use the up/down keys to highlight the Clear User Password
parameter then press Enter.
Description
Select Enabled to activate security
check during POST.
Sets the control level of the hard disk
drive.
Sets the control level of the floppy
drive.
4 BIOS setup
Option
Disabled
Enabled
Normal
Write Protect
Supervisor
Normal
Advertisement
Table of Contents
